Calling all creative and crafty bees!

posted 3 years ago in Reception
Post # 3
Member
350 posts
Helper bee
  • Wedding: December 2014

Could they be drilled? A hole through the top to place the stick into.

Otherwise I was thinking a ribbon around the neck with number card and maybe place the animal on a platform so it is raised on the table.

Cant wait to see what you do with them!

 

Post # 4
Member
1248 posts
Bumble bee
  • Wedding: April 2014

@Mrs2B000:  Could you do it so it looked like the bunny was holding it? Either glue the stick between it’s liitle paws or drill a whole like PP said and stick it through. Very cute!

Post # 6
Member
9532 posts
Buzzing Beekeeper
  • Wedding: August 2013

@Mrs2B000:  Yup – try a drill with a bit slightly larger than the dowel rod size you would like to use. Then just use glue on the end of the dowel.

Post # 7
Member
11379 posts
Sugar Beekeeper
  • Wedding: April 2012

@Mrs2B000:  i would try drilling a very small hole in the bottom to see how easy/hard it is.  if you practice on the bottom, no one will see if you make a boo boo.

how tall are they?

Post # 8
Member
5697 posts
Bee Keeper
  • Wedding: August 2012

I’m in the drill and glue camp

Post # 10
Hostess
8680 posts
Bumble Beekeeper
  • Wedding: October 2014

You could also get a thin, but sturdy wire and poke it into where the hands are.. then attatch the table number to the wire.. so it looks like the bunny is holding the signs!

If this isn’t possible, then yes I would go with the drill & dowel method.

Post # 11
Member
6964 posts
Busy Beekeeper
  • Wedding: October 2015

@Mrs2B000:  I would totally drill and glue.

But really I just wanted to say those are so freaking cute!!!

Leave a comment


Sent weekly. You may unsubscribe at any time.

Find Amazing Vendors