does your ering sit straight up?

posted 3 years ago in Rings
Post # 3
Member
11002 posts
Sugar Beekeeper
  • Wedding: May 2009

@oxstardust421xo:  Yes. As I type this, my e-ring is pointed sideways, at the wall instead of sitting up on my finger. I constantly have to twist my e-ring and wedding band into the correct positions, and, soon after, they both spin again.

I don’t like it at all.  However, I can tolerate this more than I could too-tight rings, and I do not want to have my rings soldered.

Post # 4
Member
1170 posts
Bumble bee
  • Wedding: July 2002

Mine spins to the side a lot, but it was sized bigger than I normally wear.  It is gonna have to go down because I feel the need to hold it in place with my thumb.  

Post # 5
Member
1134 posts
Bumble bee
  • Wedding: December 2014

@oxstardust421xo:  Mine stays put for the most part. I am a lefty so it does move when I write which can be quite annoying though.

Post # 6
Member
627 posts
Busy bee
  • Wedding: May 2014 - Scottish Rite Cathedral (New Castle, PA)

Mine used to spin but I my jeweler put two little metal balls into the bottom of the band and it keeps it from spinning…I think they’re called sizing beads. I had the ring sized appropriately and then had him put the beads in just to stop the spinning. Maybe look into those?

Post # 7
Member
6884 posts
Busy Beekeeper
  • Wedding: March 2014 - A castle!

@oxstardust421xo:  You can fix the top heaviness by having small little balls soldered inside the band 🙂

^Not my photo

Post # 8
Member
10219 posts
Sugar Beekeeper
  • Wedding: December 2012

A lot has to do with the design… in my experience Solitaires are a lot more prone to doing this because they are top heavy

(My first marriage circa 1980, I wore a solitaire… and it would have spun more had I not opted for a Ring Set with a Euro Shank which is flat / weighted to the bottom)

PHOTO – Solitaire ERing with a Cathedral Setting and a Euro Shank

I highly recommend Euro Shanks for anyone looking to buy a Solitaire that they don’t want to solder to their WBand.

My current ERing doesn’t spin whatsover… I attribute this to the fact that I wear it a tad snug (not tight) and the weight of the diamonds are more evenly distributed.

Lol, now my Sparkly Half-Eternity WBand… ya it moves over the course of the day.  And it bugs me, but as someone who has 3 Rings (1 ERing & 2 WBands) I like being able to wear 1, 2, or 3 rings at a time and mix & match / stack them as the mood strikes me, so I won’t be soldering any rings together.

PHOTO – My Sparkly ERing & WBand

Hope this helps,

 

Post # 11
Member
252 posts
Helper bee

Mine spins around all the time im always pushing it back.. It is my exact size if i make it any smaller it will get stuck on my finger..i guess its top heavy… ? Idk whats goingto happen when i get a wedding banddd

Post # 12
Member
786 posts
Busy bee
  • Wedding: February 2014

@oxstardust421xo:  no, it’s all over the place.  same with my rhr, ugh.  I was half-tempted to put one of those double sided, fabric sticky things on the inside the other day for it to stop spinning.

 

Post # 13
Member
3828 posts
Honey bee
  • Wedding: November 1999

Mine tends to spin during the winter. But it’s better now with my wedding band. 

Leave a comment


Sent weekly. You may unsubscribe at any time.

Find Amazing Vendors