My diy petal aisle runner and table numbers

posted 3 years ago in DIY
Post # 2
Member
1298 posts
Bumble bee
  • Wedding: November 2012

stephanie.beutke: 

you could try getting clear silicone caulk at the hardware store and putting strips of it on the back of the runner, then let dry.

Or, get some of the non-skid drawer liner stuff or the rolls of nonskid stuff you put on the back of area rugs and cut to size and glue on the back. 

ETA: both look awesome!!

Post # 4
Member
946 posts
Busy bee
  • Wedding: September 2013

stephanie.beutke:  I DIY my aisle runner much like you! Mine was in a semi-indoor venue (tent-covered patio) so I didn’t want it to blow away. I glued large aquarium stone on the edge of the underside of the runner. They are the stone with the rounded tops and flat bottoms. It weighed it down and no one slipped. For reference, the runner was on concrete.

Post # 5
Member
42522 posts
Honey Beekeeper
  • Wedding: November 1999

emstar168:  You can buy a non slip runner underlay. Generally they are 2×8″ for about $12. You just lay it on the floor and place your runner on top. There is no gluing or otherwise attaching needed.

Post # 7
Member
1701 posts
Bumble bee
  • Wedding: September 2015

stephanie.beutke:  you did a great job going to make one for my wedding where did you get the flowers? 

Post # 9
Member
354 posts
Helper bee
  • Wedding: December 2014

Love your numbers do you mind sharing how you did it x

Post # 10
Member
1321 posts
Bumble bee
  • Wedding: April 2015

very nice.

Post # 11
Member
132 posts
Blushing bee
  • Wedding: July 2014

I Love your runner!! It looks great

Leave a comment


Sent weekly. You may unsubscribe at any time.

Find Amazing Vendors