This may be a dumb question but….

posted 3 years ago in Rings
Post # 2
Member
397 posts
Helper bee
  • Wedding: July 2013

they would have to move the halo diamonds as well which could result in a loose setting. It could be done though.

Post # 3
Member
327 posts
Helper bee
  • Wedding: May 2016

I was having the same dilemma and  I contacted Verragio about it. It is possible by completely replacing the head of the ring which will cost me $1000

Post # 4
Member
92 posts
Worker bee
  • Wedding: August 2002

It depends on the style of the halo.  Do you have a picture?

Post # 5
Member
3359 posts
Sugar bee
  • Wedding: February 1997

Normally a halo cannot accomodate a larger stone without the new stone sitting higher than the original and possibly obscuring part of the halo. I recall a ring on the bee once where someone did that, though, and it actually was quite stunning. It made the halo much less noticeable. Most people didn’t like the look, but I did.

In settings where the stone sits flush with the halo, then no, it cannot accomodate either a larger or smaller stone than what is in it. A larger stone would not fit (and sit flush like the original), and a smaller stone would leave an airline. Ultimately, most halos are built to accomodate the stone they are holding and wouldn’t do well with another size. Normally if a person wanted it set the same as the original, the halo would have to be remade.

Leave a comment


Sent weekly. You may unsubscribe at any time.

Find Amazing Vendors