(Closed) Calling Three Stones and Big Rings!

posted 4 years ago in Rings
Post # 3
Member
12257 posts
Sugar Beekeeper
  • Wedding: May 2013

@steph_lady:  I wear a size 4.5-5, have 1ct center, and could TOTALLY fit two more 1ct stones on there–so I’m sure you’ll be fine.

The thing to be careful of is with high-setting stones, you scratch EVERYTHING with your setting! You, your FI, small children (I wanted to die). So careful with how high it is!

Post # 5
Member
100 posts
Blushing bee

I have a 3 stone– 1.25 round center with .33 each sides. It is roughly the full width of my finger, just a tiny bit smaller. I wear a 5.5.

2- 1ct plus a half would be…what, like 17mm, before the halo? that is a big ring. Mine is 17mm so about the same size.

 

Post # 7
Member
100 posts
Blushing bee

I would have to get out calipers to measure it, but I would guess it is about 8mm off my finger at the highest point. That is the center stone, the side stones are tucked underneath it at 4-5mm high.

This is as low as the center could possibly go and have the 2 side stones tuck underneath–if you wanted all 3 to be equal, you could go a little lower. However, if you have to make room for a halo that will sit ABOVE the 2 side stones, then this would probably be as low as you could go.

The topic ‘Calling Three Stones and Big Rings!’ is closed to new replies.

Get our weekly roundup of the best of Weddingbee.
I agree to receive emails from the site. I can withdraw my consent at any time by unsubscribing.

Find Amazing Vendors