Post # 1

Member
563 posts
Busy bee
I was wondering if anyone could tell me about their experience printing their own direction cards or other inserts. Did you use a regular printer? Did you cut down an 81/2 by 11 sheet or start with smaller cardstock? Where can you buy small cardstocck?
Thank you so much for your assistance!
Post # 3

Member
1022 posts
Bumble bee
I would recommend printing two or three to a 8-1/2 by 11 sheet. That is what we are planning on doing. If you want smaller cardstock, you could by the 8-1/2 by 11 paper and have it cut at Kinko’s or Office Depot for a small fee. I think Papersource sells smaller sizes if you want to go that route, I’ve just not had good luck with printing on smaller sized paper with my home printer.
Good luck!
Post # 4

Member
563 posts
Busy bee
Thanks – I’ll have to try that!
Post # 5

Member
129 posts
Blushing bee
I lay everything out to print multiple per page, print on 8.5×11 paper, and then cut afterward. Getting it cut at Kinkos is the easiest, but comes with a (tiny) cost; cutting them yourself can be a little more annoying. But trying to fight with a printer to take small pieces of paper is by far the most frustrating of all!