(Closed) Wedding band to go with knife edge engagement ring?

posted 5 years ago in Rings
Post # 4
Member
1649 posts
Bumble bee
  • Wedding: July 2012

Are you looking for something that will sit flush, or do you think you’ll like a small gap?

Post # 5
Member
1245 posts
Bumble bee
  • Wedding: November 1999

Do you want a diamond band?

I have a knife edge 3 stone ring and usually wear it alone, but here’s a not so great picture of it with a shared prong half eternity band.

If you want a plain band, I find matching knife edge bands look great.

 

Post # 6
Member
5001 posts
Bee Keeper
  • Wedding: September 2013

Does it not look right with a flat band? Like an eternity band with round stones? I think that would be really classic and beautiful!

Post # 8
Member
1245 posts
Bumble bee
  • Wedding: November 1999

Here’s another bad picture (I swear I can never get the shots some of these ladies get!) of the kinfe edge ring with a flat diamond band (a channel set band).  I think that look is nice too.

Post # 9
Member
114 posts
Blushing bee

I have a 6-prong, knife-edge e-ring with a “donut” at the bottom of the prongs as well. I’m pairing it with a straight, shared-prong diamond band. (I prefer it over curved bands because I want to be able to wear the band alone at times.) I have a tiny gap, but I rather like the look. 😀

 

Post # 11
Member
240 posts
Helper bee
  • Wedding: March 2013

I have a low set knife edge also and it sit quite flush with my wedding band.

Post # 12
Member
2607 posts
Sugar bee
  • Wedding: September 2011

I love LOVE a knife-edge diamond band.

Post # 13
Member
90 posts
Worker bee
  • Wedding: December 2013

@MissNoodles: I have never seen that. It,S quite nice!!

Post # 14
Member
3063 posts
Sugar bee
  • Wedding: November 2012

@gatystar:  Here’s my knife edge and bezel eternity

Post # 15
Member
64 posts
Worker bee
  • Wedding: April 2014

I have a super low profile eternity, 2mm. It sits pretty flush against my knife edge. I almost wish there was more of a gap. I ordered a 1mm spacer ring from etsy, and I might try ordering a 3mm eternity or semi-eternity because I want a band that’s a little more substantial. But if you’re looking for something that will sit flush against your ring, I’d get a small low profile eternity

Post # 16
Member
64 posts
Worker bee
  • Wedding: April 2014

Woops I accidentally double posted. Here’s another pic from the side…

The topic ‘Wedding band to go with knife edge engagement ring?’ is closed to new replies.

Find Amazing Vendors